3D-Micromac systems for Infineon
Laser micromachining expert exclusively supplies new Dresden Smart Power Fab with the microVEGA FC laser-trimming system.
Both companies share a goal of installing 3D-Micromac AG’s laser-trimming systems at more of Infineon’s production sites. The first ordered system, designed specifically for Infineon, will be installed at its Smart Power Fab for use in the production of analog/mixed-signal technologies and power semiconductors.
The order was preceded by a joint-development project in which 3D-Micromac’s lasertrimming process was transferred into a mass-production-capable laser system. The basis for the new solution was the microVEGA system – a system that has already been utilized successfully to process up to 300-mm (12-inch) semiconductor wafers in several industrial use cases.
The laser beam of the microVEGA FC is shaped in the single-digit micrometer range and moves continuously over semiconductor chips. During this motion, the laser selectively processes defined microstructures of several dies. This trimming process adjusts the resistance value in individual IC chips to a target value. The small size of the dies’ structures (approximately 1 – 2 µm) and the resulting extremely high demands on the threedimensional positioning accuracy of the laser spot in relation to the structures place the highest demands on the machine hardware. The microVEGA FC includes an integrated measuring technology to achieve 100-percent process control, overcoming a particular challenge in semiconductor laser-trimming applications. The microVEGA FC system features fully automatic handling for 200 and 300-mm wafers. At process speeds of up to 400 mm/s, the system achieves a positioning accuracy of ±200 nm (at 3 sigma).
Infineon plans to begin manufacturing analog/mixed-signal technologies and power semiconductors in Dresden's Smart Power Fab in the fall of 2026. The interaction of power semiconductors and analog/mixed-signal components enables particularly energy-efficient and intelligent system solutions commonly used in power supply systems, such as energyefficient chargers, smaller engine control units for cars, data centers, and Internet of Things (IoT) applications.
Further reading: Hans-Ulrich Zuehlke, Mandy Gebhardt (both: 3D-Micromac): Cost-Effective Production of Integrated Monolithic Sensor Packages – Selective laser annealing enables the setting of different reference magnetization directions on sensors, PhotonicsViews 18(2), April/May 2021, 32-35, first published: 14 April 2021; DOI:
10.1002/phvs.202100032
Company
Infineon Technologies AGAm Campeon 1-15
85579 Neubiberg
Germany
most read
Infineon and Marelli enter new era of cockpit design
MEMS laser beam scanning for an immersive car display experience.
A New Era of Smart Manufacturing Begins
The inaugural SPS – Smart Production Solutions Atlanta starts soon, marking a significant milestone in the evolution of the SPS brand.
Machine vision subsidiary Realsense splits from Intel
Realsense, a company specializing in AI-based machine vision, is being spun off from Intel Corporation. At the same time, it has completed another round of financing.
The winners of the inspect award 2025
This time, with two additional categories, “SMEs” and “Artificial Intelligence,” the selection was even larger than usual. But now they have been chosen: the machine vision products of the year 2025.
Qioptiq Photonics becomes Excelitas Germany
The renaming is part of the global consolidation of the Excelitas Group.